If not, it is necessary to meet these requirements. Handling and repairing methods for Spray Printing Embroidery Machine Suppliers embroidering tricks in the embroidering process of the embroidery machine: 1.5 to 2 mm, and the tip of the hook must be in a straight line with the needle, and the back plane of the needle and the tip of the hook must maintain a distance of one strand of hair.

The mechanical drive parts of the embroidery frame are defective, and the shaft coected to the stepper motor is loose-adjust or replace The belt tension of the embroidery frame drive is poor or there are foreign objects on the drive track of the embroidery frame-adjust the belt tension (or clean the track).

Accessories depend on the machine.ufeffA certain machine head of a computerized embroidery machine will especially break the thread, which can be dealt with by the following process: If you pull it out and sell it as scrap, you will need to replace a lot of things if you don’t repair it. It is necessary that the lower end of the needle hole is below the tip of the hook. First touch the hook with your hands, whether there is any burr, yes, change it. See if there are burrs in the needle plate, and it is necessary to polish it with sandpaper To 4.

Hold the jumper wire A with your hand, and swing it up and down around 250 degrees to see if the cam gap is large and small, and whether the 7. The trick data is wrong, correct the trick from the begiing or input the embroidery trick from the begiing Defective stepper motor driver in X and Y direction of embroidery frame-replace the defective stepper driver If the above methods are not able to be tried, just press down the needle, hold the needle clamp with your hand, and move it up and down. The slider, the 'driver' and the aluminum coecting rod, small coecting rod, Inject butter into the Dalian rod to reduce the gap. I can think of any specific methods. 

امتیاز بدهید :